goraedu

When Does OSHA Require a Debris Chute on a Construction Site? What 29 CFR 1926.252 Says About Dropping Waste

OSHA's construction standard 29 CFR 1926.252 requires an enclosed chute whenever materials are dropped more than 20 feet to any point outside the exterior walls of the building. When debris is dropped through floor holes without chutes, the landing area must be completely enclosed with barricades at least 42 inches high and at least 6 feet back from the projected edge of the opening above, with warning signs at each level. The section also covers removing scrap as work progresses, burning, and storing oily rags and solvent waste.

OSHA construction safetyExplainerPublished

Fact-checked against official sources · Last checked

Card reading OSHA construction safety, Explainer: Debris chutes and dropping waste: 29 CFR 1926.252. eCFR, Nov 16, 2026
Image: goraedu · Own work

For OSHA construction safety, the federal rule on dropping debris and disposing of waste on a job site is 29 CFR 1926.252, "Disposal of waste materials," in Subpart H (Materials Handling, Storage, Use, and Disposal) of the construction standards. This explainer reads the section as it stands in the eCFR (current to November 12, 2026). Nothing here describes a rule change, and it does not cover general industry workplaces under Part 1910.

When is a chute required?

1926.252(a) states: "Whenever materials are dropped more than 20 feet to any point lying outside the exterior walls of the building, an enclosed chute of wood, or equivalent material, shall be used."

That sentence has three parts:

  • Distance: the drop is "more than 20 feet."
  • Where it lands: "any point lying outside the exterior walls of the building."
  • What is required: "an enclosed chute of wood, or equivalent material."

The rule does not tie the chute requirement to the type of material; it says "materials."

What counts as an enclosed chute?

The same paragraph defines it: "For the purpose of this paragraph, an enclosed chute is a slide, closed in on all sides, through which material is moved from a high place to a lower one."

The chute must be "closed in on all sides."

What if debris is dropped through a hole in the floor?

1926.252(b) covers dropping debris through holes in the floor without chutes: "When debris is dropped through holes in the floor without the use of chutes, the area onto which the material is dropped shall be completely enclosed with barricades not less than 42 inches high and not less than 6 feet back from the projected edge of the opening above."

The same paragraph adds two more requirements:

  • "Signs warning of the hazard of falling materials shall be posted at each level."
  • "Removal shall not be permitted in this lower area until debris handling ceases above."

In short, the landing area is completely enclosed with barricades at least 42 inches high and at least 6 feet back from the projected edge of the opening above, warning signs go up at each level, and nobody removes debris from the lower area until debris handling above has ceased.

Does scrap have to be cleared as the job goes?

Yes. 1926.252(c) states: "All scrap lumber, waste material, and rubbish shall be removed from the immediate work area as the work progresses."

Can waste be burned on site?

1926.252 sets no burning conditions of its own; it points to local fire regulations. 1926.252(d) states: "Disposal of waste material or debris by burning shall comply with local fire regulations." The section itself sets no other burning conditions.

How must oily rags and solvent waste be kept?

1926.252(e) states: "All solvent waste, oily rags, and flammable liquids shall be kept in fire resistant covered containers until removed from worksite."

The containers must be both "fire resistant" and "covered," and the rule applies "until removed from worksite."

What this means for OSHA study

The numbers to know from 1926.252 are more than 20 feet (the drop above which an enclosed chute is required for drops to points outside the exterior walls), 42 inches (minimum barricade height) and 6 feet (minimum setback from the projected edge of the opening). Our OSHA construction general safety study guide covers housekeeping and other general site rules, and the general safety practice test lets you check yourself. See every topic on the OSHA construction hub. Our questions are our own, written from the regulation.

Sources

Found an error? Email [email protected]. We review reports within 7 days and log fixes on the corrections page.